![]() ![]() ![]() Press the button ‘Query Logger’ and it shows “Query successful” after it read all the parameters.Ĭompare the RTU Network ID from the sticker associated with the L900 RSTAR RTU with the RTU Network ID shown on the dialog box. To set the RTU Network ID, press ‘Advanced’ button to bring up the settings menu. (For the 1 st DT Logger, the password “coq” is required to enable editing the RTU Settings but it is not required if you edit more than one DT Logger after the 1 st one) To edit the L900 RSTAR RTU settings, press ‘Enable Edit’ and enter ‘coq’ as the Password dialog pops up.Įnter the L900 RSTAR RTU’s details from the sticker in the FlexDAQ box, usually in proximity of the L900 RSTAR RTU and press ‘Update Logger’ to send the settings to the L900 RSTAR Node in the DT Logger. Also, the corresponding data logger type connected will turn green.īrowse to ‘Connections Tab’, select RSTAR option and press on ‘Wireless Settings’ to go into the RSTAR Setup Menu.Ĭlick on the Sync button, if it is showing Sync failed in red, the RSTAR network is not setup correctly and no communication is established. Once it is recognized and connected, the Status shows ‘USB Connected V‘ in Green color. When no device is connected, the Status shows “Disconnected X” in Red color. Open the DT Logger Host software, it scans and detects the DT Series Data Logger. Solution: follow the steps in the guide below to do this job.įirst, connect the PC running DT Logger Host Software to DT Series Data Logger by a mini–USB Cable. Scenario: customer needs to connect a DT Series Data Logger to a FlexDAQ via RSTAR L900 RTU/ Node and DT Logger Host Software. Modified on: Tue, 10 May, 2022 at 8:06 AM #Ups logger id how to#Solution home FAQs DT LINK WIRELESS DATA COLLECTION FROM DATA LOGGERS How to setup wireless communication between DT Loggers and FlexDAQ ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |